SilverHolder™ Dynamic Car Hood LED Strip

Car batteries are located in different places in different vehicles. Most models hold the battery under the bonnet in one of the front corners. However, some batteries are located in the car boot to balance weight distribution. Check your vehicle handbook to find the location of your model’s battery.

Once you’ve checked your handbook, the car battery should be easy to identify. Look for a black, box-shaped battery with two large cables connected to the top. These cables are the positive and negative electrical terminals. Most car batteries measure around 6 by 10 inches, so you shouldn’t be able to miss yours.

Red wire to Car ACC  / Black wire to a ground / Yellow wire to the turn signal (+) left/right

The product shown in the video below is a car led stripe.

There are three lines in the video: red, black, and yellow. But there is an extra wire for the car hood light stripe, you can just connect the fourth wire according to the schematic in the picture below

Function 1: 

Change static effect to running water effect；- Long press (-B) button

Function 2: 

When you crop the light bar, the dynamic effect is not centred;

Ⅰ. Long press the (+A) button to enter the adjustment mode.
Ⅱ. Short press (+A) or (-B), adjust the centre position
Ⅲ. When adjustment is complete, long press (+A) button to exit adjustment mode;

Function 3: 

Adjust the length of the yellow turn signal

Ⅰ. Put the light stripe in yellow constant state
Ⅱ. Long press the (+A) button to enter the adjustment mode.
Ⅲ. Short press (+A) or (-B), adjust the centre position
Ⅳ. When adjustment is complete, long press (+A) button to exit adjustment mode;